Wushu Cutout grip in raw, uncoated SLS carbon fiber composite before vapor polishing and Cerakote

What Is Selective Laser Sintering (SLS)?

Selective laser sintering, or SLS, is an advanced additive manufacturing process that builds solid parts from fine polymer powder using a laser. It's how every Tapp Tactical grip starts. Here's how it works in plain terms.

How SLS works

  1. Spread. A thin layer of powder, in our case carbon-fiber-reinforced nylon, is spread across a heated build chamber.
  2. Sinter. A laser traces the cross-section of each part, fusing the powder particles together.
  3. Repeat. The platform drops by a fraction of a millimeter, a fresh layer of powder is spread and the laser fuses the next cross-section onto the one below.
  4. Cool. The finished build cools slowly inside its block of powder, which helps keep parts dimensionally stable.
  5. Break out and clean. Parts are removed from the powder and cleaned of any loose material.

Because the unfused powder supports each part as it's built, SLS needs no support structures. That's what makes shapes like our cutout windows and undercuts possible.

Why carbon-fiber-reinforced nylon

PA11 is a tough, impact-resistant nylon made from renewable castor-oil feedstock. Reinforcing it with carbon fiber raises its stiffness and heat resistance. The material data sheet (X axis) lists:

Property Value
Ultimate tensile strength 69 MPa
Flexural strength 110 MPa
Flexural modulus 4.2 GPa
Heat deflection temperature 178 °C (352 °F) at 1.8 MPa

These are material values from the data sheet, not measurements of a finished grip.

What happens after sintering

A part fresh out of the powder has a matte, slightly sandy surface. Every Tapp Tactical grip then goes through three more steps:

  • Vapor polishing for a smooth, sealed, very strong finish (how it works)
  • Cerakote in the color you choose, oven-cured (why Cerakote)
  • Inspection for fit and finish before it ships with a grip screw

Why we use SLS for a grip

  • Ergonomic shapes without the limits of a mold, including open windows and undercuts
  • A stiff, heat-resistant carbon fiber composite
  • Every grip made to order in the USA, in the model and color you choose

See the whole process on our materials and process page, or compare SLS with molding in SLS carbon fiber vs injection-molded grips.

Made to order in the USA. Ships in 3–5 business days. Custom (“Other”) colors can add up to 10 business days.

Build your grip

Back to blog

FAQ

What does SLS stand for?

Selective laser sintering: an advanced additive manufacturing process that uses a laser to fuse polymer powder into solid parts, one thin layer at a time.

What is PA11?

PA11 is a nylon made from castor-oil-derived feedstock, known for toughness and impact resistance. Ours is reinforced with carbon fiber for extra stiffness.

Why don't SLS parts need support structures?

The unfused powder around each part supports it during the build, so complex shapes like cutout windows come out without supports to remove.

Build your grip

Four profiles, any Cerakote color, made to order in the USA. Ships in 3–5 business days.

Open the builder

More guides