Standard grip in OD Green Cerakote installed on a grey AR-15 lower receiver

How to Install an AR-15 Pistol Grip (Step by Step)

Swapping a pistol grip is one of the easiest upgrades on an AR-15. It takes about ten minutes, needs one tool and no gunsmithing. The only part to respect is the small safety selector detent spring that lives inside the grip. Follow the steps below and it stays exactly where it should.

What you need

  • A hex key or flat-blade screwdriver that fits your grip screw
  • Your new grip and grip screw (every Tapp Tactical grip ships with one)
  • A small magnetic tray or cup for the detent spring
  • Good light and a clean work surface

Step by step

  1. Make the rifle safe. Remove the magazine, lock the bolt to the rear and check the chamber visually and physically. Keep ammunition out of the work area.
  2. Set the selector to SAFE. This keeps the detent in a known position while you work.
  3. Remove the grip screw. Turn the rifle upside down and back the screw out of the bottom of the grip while holding the grip against the receiver.
  4. Slide the old grip off slowly. The selector detent spring sits in a channel at the top of the grip under light tension. Ease the grip down and catch the spring. The detent is a small pin that normally stays in the receiver; make sure it doesn't fall out.
  5. Seat the spring in the new grip. Drop the detent spring into the matching channel on your new grip. Confirm the detent is still in its hole in the receiver, pointed end toward the selector.
  6. Fit the new grip. Slide the grip up onto the receiver, guiding the spring onto the detent. Keep light upward pressure so the spring stays captured.
  7. Install the grip screw. Start the screw by hand, then snug it with the tool. Stop once the grip is firmly seated; overtightening can damage the threads in the receiver.
  8. Run a function check. With the rifle still unloaded, cock the hammer, set SAFE and pull the trigger: the hammer must not fall. Set FIRE, pull and hold the trigger: the hammer falls. Keep holding, cycle the charging handle, then slowly release the trigger: you should feel and hear the reset. The selector should click positively between positions.

If the selector feels mushy or won't stay in position, the spring isn't riding on the detent. Remove the grip, re-seat the spring and repeat the function check. Don't use the rifle until it passes.

Will a Tapp Tactical grip fit my rifle?

Every model fits mil-spec AR-15 lower receivers and installs with the included grip screw. They do not fit AR-10 / LR-308 rifles; an AR-10 version is coming soon. See the fitment page or our AR-15 grip fitment guide.

Choose your grip

Four profiles (Standard, Standard Cutout, Wushu and Wushu Cutout) in Black, FDE, OD Green or any Cerakote color. Not sure which? Start with the buying guide or compare Standard and Wushu.

Made to order in the USA. Ships in 3–5 business days. Custom (“Other”) colors can add up to 10 business days.

Open the grip builder

Back to blog

FAQ

Do I need a gunsmith to change an AR-15 grip?

No. A grip swap needs one hex key or screwdriver and about ten minutes. The only part to watch is the safety selector detent spring that sits inside the grip.

What happens if I lose the safety detent spring?

The selector won't click into position reliably. Replacement detent springs are inexpensive and widely available. Don't use the rifle until the spring is replaced and the function check passes.

Does a Tapp Tactical grip come with a screw?

Yes. Every grip ships with a grip screw.

Build your grip

Four profiles, any Cerakote color, made to order in the USA. Ships in 3–5 business days.

Open the builder

More guides